DSG-01-2B3B-D24-N-50,日本YUKEN电磁换向阀
FOR COMPLETE OPERATING INSTRUCTIONS, REFER TO “OPERATORS
INSTRUCTION MANUAL” PUB. EM-0448. （DSG-01-70 SERIES）
★ MOUNTING
No-spring detented models not energized continuously must be installed so that the
spool axis L-L' on pages 1/3 will be horizontal. Other models are not restricted as to
mounting. horizontal.
★ ENERGIZATION除了标准的两个位置阀门的型号表所示
左，二种阀的位置和两个偏移位置中的任个。
标准和反向安装类型使用“b”和电磁线圈“a”分别。请参阅
酒吧：ALA-0402-70-2两个位置的阀配置备用。
􀂇位置的阀门和个偏移位置（两个特殊位置
阀）和反向安装的电磁阀。
􀂇孔板
★孔可以插入在，无论P，A，B或T口。然而，在这种情况下，差压
在该孔应设置低于3045 PSI。
★情况下的节流孔被插入在T-口，在阀的油箱管路压力应小于
的zui大的T型线背压。
★如孔板差压超过3045 PSI进行特殊设计，咨询油研
阀门有螺纹P，A，B口。
On double solenoid valves do not energize both at the same time as it will result in
coils burning out.
★ VALVE TANK PORT
Connection of valve tank port to a line where surge pressure is likely to occur is to be
avoided. Piping end of tank line should be submerged in oil.
★ VALVE TIGHTENING TORQUE OF MOUNTING BOLT
44～62 IN・lbs
（Applicable to working pressure more than 3625 PSI : 53～62 IN・lbs）
★ OPERATING FORCE BY MANUAL ACTUATOR
Take care as the operating force by the manual actuator increases in proportion to the
tank line back pressure. （See the below graph.）

DSG-01-2B3B-D24-N-50,日本YUKEN电磁换向阀