美国VICKERS流量控制阀，伊顿威格士流量控制阀
13应用凡士林到108 mm [ 4.25英寸内径密封，并安装在
轴承箱的密封槽见图。 14 。
14应用凡士林9,4毫米[ 0.37英寸内径密封。在安装密封
壳体泄槽轴承座。
15安装2螺栓（早期型号） ，对角线相对的，在螺栓孔
轴承座，见图。 15 。如果你用螺栓更换螺栓，使用2
螺柱堆放的零件时，对齐的目的。
18在输出轴花键安装驱动。对于345立方厘米/ R [ 21.0立方英寸/ R]
排量马达驱动器插入较长的花键结束*，见图。 16 。
19应用凡士林2封9,4毫米[ 0.37英寸] ID和2封
108毫米[ 4.25英寸]内径在摆线的密封槽安装它们，
参见图16 ， （在摆线的两侧各密封件中的个） 。
注意：安装在这点涉及的时序3步骤
电机。定时确定所述输出轴的旋转方向。
16 Install thrust washer and thrust bearing in wear plate – washer first,
see Fig. 15. A light film of lubricant on the washer and bearing will
help hold them in place.
17 Align case drain hole in wear plate with case drain hole in bearing
housing. Install wear plate flush against bearing housing, see Fig. 15.
Timing Step 1—Locate the largest open pocket in the Geroler and
mark it on the outside edge of the Geroler, See Fig. 17.
20 Align case drain hole in Geroler with case drain hole in wear-plate.
Install Geroler on wear plate, see Fig. 16. Be sure to retain rollers in
21 Install valve drive in Geroler.
22 Align case drain hole in valve plate with case drain hole in Geroler.
Install valve plate flush against Geroler, see Fig. 17.
Timing Step 2—Locate the slot opening in the valve plate which is in
line with the largest open pocket of the Geroler. See Fig. 17
 

美国VICKERS流量控制阀，伊顿威格士流量控制阀